EXPERIMENTAL PROCEDURE!
Use at your own risk
STG13 - Distance control > Access authorization: S12345 >
STG13 - Distance control > Access authorization: 20103 >
Now select the following adjustment channels and save the value [0.00] in each case. Even if [0.00] is already in there, just enter the value again and save it!
STG13 - Distance control > Adjustment >
ENG253006-MAS13427-Correction angle-Horizontal correction angle dynamic
ENG253006-MAS13428-Correction angle-vertical correction angle dynamic
ENG253006-MAS13429-Correction angle-horizontal correction angle current
ENG253006-MAS13430-Correction angle-vertical correction angle actual
ENG253002-Misalignment_angle_horizontal_adaptation
ENG253003-Misalignment_angle_vertical_adaption
Now drive a distance of approx. 15 - 20km, there should be traffic, so that the sensor can recalculate the correction angles. Check the values after the test drive.
The angle may be between 0.80° and -0.80°, if the system is outside the value, the sensor must be realigned.
--- IN PROGRESS---
If you are interested, please contact VCDS.de support.
Dynamic calibration is only available from software 0620 (Index H) and H10. All systems before that can only be calibrated statically!
STG13 - Distance control > Access authorization: S23456 >
STG13 - Distance control > Access authorization: 20103 >
Now select the following adjustment channels and save the value [0.00] in each case. Even if [0.00] is already in there, simply enter the value again and save!
STG13 - Distance control > Adjustment >
IDE11924-MAS13427-Correction angle-Horizontal correction angle dynamic
IDE11924-MAS13428-Correction angle-vertical correction angle dynamic
IDE11924-MAS13429-Correction angle-horizontal correction angle actual
IDE11924-MAS13430-Current correction angle-vertical correction angle
IDE08936-Dejustment angle horizontal
IDE09906-Dejustment angle vertical
Now drive a distance of approx. 15 - 20km, there should be traffic, so that the sensor can recalculate the correction angles. Check the values after the test drive.
The angle may be between 2.00° and -2.00°, if the system is outside the value, the sensor must be realigned.
But experience shows that the value should be between 1.00° and -1.00° to get the best result. In this case, the sensor must be mechanically realigned.
STG13 - Distance control > Measured values >
STG13 - Distance control > Access authorization: 11111
STG13 - Distance control > Access authorization: 20103
STG13 - Distance control > Basic settings >
Reset misalignment angle for sensors
Now clear the fault memory and carry out a test drive of approx. 15 - 20km.
Now drive a distance of approx. 15 - 20km, there should be traffic so that the sensor can recalculate the correction angles. Check the values after the test drive.
The angle may be between 3.00° and -3.00°, if the system is outside the value, the sensor must be realigned.